Nonlinear damping, the change in damping rate with the amplitude of oscillations plays an important role in many electrical, mechanical and even biological oscillators. In novel technologies such as carbon nanotubes, graphene membranes or superconducting resonators, the origin of nonlinear damping is sometimes unclear. This presents a problem, as the damping rate is a key figure of merit in the application of these systems to extremely precise sensors or quantum computers. Through measurements of a superconducting resonator, we show that from the interplay of quantum fluctuations and the nonlinearity of a Josephson junction emerges a power-dependence in the resonator response which closely resembles nonlinear damping. The phenomenon can be understood and visualized through the flow of quasi-probability in phase space where it reveals itself as dephasing. Crucially, the effect is not restricted to superconducting circuits: we expect that quantum fluctuations or other sources of noise give rise to apparent nonlinear damping in systems with a similar conservative nonlinearity, such as nano-mechanical oscillators or even macroscopic systems.

Photon-pressure coupling between two superconducting circuits is a promising platform for investigating radiation-pressure coupling in distinct parameter regimes and for the development of radio-frequency (RF) quantum photonics and quantum-limited RF sensing. Here, we implement photon-pressure coupling between two superconducting circuits, one of which can be operated as a parametric amplifier. We demonstrate a Kerr-based enhancement of the photon-pressure single-photon coupling rate and an increase of the cooperativity by one order of magnitude in the amplifier regime. In addition, we observe that the intracavity amplification reduces the measurement imprecision of RF signal detection. Last, we demonstrate that RF mode sideband cooling is unexpectedly not limited to the effective amplifier mode temperature arising from quantum noise amplification, which we interpret in the context of nonreciprocal heat transfer between the two circuits. Our results demonstrate how Kerr amplification can be used as resource for enhanced photon-pressure systems and Kerr cavity optomechanics.

Cavity optomechanics has achieved groundbreaking control and detection of mechanical oscillators, based on their coupling to linear electromagnetic modes. Recently, however, there is increasing interest in cavity nonlinearities as resource in radiation-pressure interacting systems. Here, we present a flux-mediated optomechanical device combining a nonlinear superconducting quantum interference cavity with a mechanical nanobeam. We demonstrate how the Kerr nonlinearity of the circuit can be used to enhance the device performance by suppressing cavity frequency noise, and for a counter-intuitive sideband-cooling scheme based on intracavity four-wave-mixing. With a large single-photon coupling rate of up to g₀ = 2π ⋅ 3.6 kHz and a high mechanical quality factor Q_m ≈ 4 ⋅ 10⁵, we achieve an effective four-wave cooperativity of Cfw>100 and demonstrate four-wave cooling of the mechanical oscillator close to its quantum groundstate. Our results advance the recently developed platform of flux-mediated optomechanics and demonstrate how cavity Kerr nonlinearities can be utilized in cavity optomechanics.

Nonlinear Josephson circuits play a crucial role in the growing landscape of quantum information and technologies. The typical circuits studied in this field consist of qubits, whose anharmonicity is much larger than their linewidth, and also of parametric amplifiers, which are engineered with linewidths of tens of MHz or more. The regime of small anharmonicity but also narrow linewidth, corresponding to the dynamics of a high-Q Duffing oscillator, has not been extensively explored using Josephson cavities. Here, we use two-tone spectroscopy to study the susceptibility of a strongly driven high-Q Josephson microwave cavity. Under blue-detuned driving, we observe a shift of the cavity susceptibility, analogous to the AC Stark effect in atomic physics. When applying a strong red-detuned drive, we observe the appearance of an additional idler mode above the bifurcation threshold with net external gain. Strong driving of the circuit leads to the appearance of two exceptional points and a level attraction between the quasimodes of the driven cavity. Our results provide insights on the physics of driven nonlinear Josephson resonators and form a starting point for exploring topological physics in strongly-driven Kerr oscillators.

Quantum control of electromagnetic fields was initially established in the optical domain and has been advanced to lower frequencies in the gigahertz range during the past decades extending quantum photonics to broader frequency regimes. In standard cryogenic systems, however, thermal decoherence prevents access to the quantum regime for photon frequencies below the gigahertz domain. Here, we engineer two superconducting LC circuits coupled by a photon-pressure interaction and demonstrate sideband cooling of a hot radio frequency (RF) circuit using a microwave cavity. Because of a substantially increased coupling strength, we obtain a large single-photon quantum cooperativity q0 ∼ 1 and reduce the thermal RF occupancy by 75% with less than one pump photon. For larger pump powers, the coupling rate exceeds the RF thermal decoherence rate by a factor of 3, and the RF circuit is cooled into the quantum ground state. Our results lay the foundation for RF quantum photonics.

The radiation-pressure coupling between two harmonic oscillators has been used in optomechanics for breakthrough experiments in the control and detection of mechanical displacement. Used primarily in optomechanics, there have been few reports of exploiting such a type of interaction in other platforms. Here, we engineer two superconducting LC circuits coupled by a strong photon-pressure interaction, a term we use in analogy to the radiation-pressure interaction between light and mechanical objects. The coupling arises from a change in the resonant frequency of one circuit in response to the current flowing in the second. We observe dynamical backaction between the two circuits, photon-pressure-induced transparency and absorption, and enter the strong coupling regime. Furthermore, we observe parametrically amplified thermal current fluctuations in a radiofrequency circuit close to its quantum ground state. Owing to the high design flexibility of superconducting circuits, our approach will enable new experiments with radiofrequency photons and parameter regimes of photon-pressure coupling that are not accessible in other platforms.

We present the design, measurement, and analysis of a current sensor based on a process of Josephson parametric upconversion in a superconducting microwave cavity. When a coplanar waveguide is terminated with a nanobridge-constriction Josephson junction, we observe modulation sidebands from the cavity that enable highly sensitive frequency-multiplexed output of small currents for applications such as readout of transition-edge sensor arrays. We derive an analytical model to reproduce the measurements over a wide range of bias current, detuning, and input power. When the frequency of the cavity is tuned by more than 100 MHz with a dc current, our device achieves a minimum current sensitivity of 8.9pA/Hz. Extrapolating the results of our analytical model, we predict an improved device based on our platform, capable of achieving a sensitivity down to 50fA/Hz, or even lower if one can take advantage of parametric amplification in the Josephson cavity. Taking advantage of the Josephson architecture, our approach can provide higher sensitivity than kinetic inductance designs, and potentially enables detection of currents ultimately limited by quantum noise.

Microwave optomechanical circuits have been demonstrated to be powerful tools for both exploring fundamental physics of macroscopic mechanical oscillators, as well as being promising candidates for on-chip quantum-limited microwave devices. In most experiments so far, the mechanical oscillator is either used as a passive element and its displacement is detected using the superconducting cavity, or manipulated by intracavity fields. Here, we explore the possibility to directly and parametrically manipulate the mechanical nanobeam resonator of a cavity electromechanical system, which provides additional functionality to the toolbox of microwave optomechanics. In addition to using the cavity as an interferometer to detect parametrically modulated mechanical displacement and squeezed thermomechanical motion, we demonstrate that this approach can realize a phase-sensitive parametric amplifier for intracavity microwave photons. Future perspectives of optomechanical systems with a parametrically driven mechanical oscillator include exotic bath engineering with negative effective photon temperatures, or systems with enhanced optomechanical nonlinearities.

High-gain and low-noise signal amplification is a valuable tool in various cryogenic microwave experiments. A microwave optomechanical device, in which a vibrating capacitor modulates the frequency of a microwave cavity, is one technique that is able to amplify microwave signals with high gain and large dynamical range. Such optomechanical amplifiers typically rely on strong backaction of microwave photons on the mechanical mode achieved in the sideband-resolved limit of optomechanics. Here, we observe microwave amplification in an optomechanical cavity in the extremely unresolved sideband limit. A large gain is observed for any detuning of the single pump tone within the cavity linewidth, a clear indication that the amplification is not induced by dynamical backaction. By being able to amplify for any detuning of the pump signal, the amplification center frequency can be tuned over the entire range of the broad cavity linewidth. Additionally, by providing microwave amplification without mechanical amplification, we predict that by using this scheme it is possible to achieve near-quantum-limited microwave amplification despite a large thermal occupation of the mechanical mode.

The field of optomechanics has emerged as leading platform for achieving quantum control of macroscopic mechanical objects. Implementations of microwave optomechanics to date have coupled microwave photons to mechanical resonators using a moving capacitance. While simple and effective, the capacitive scheme suffers from limitations on the maximum achievable coupling strength. Here, we experimentally implement a fundamentally different approach: flux-mediated optomechanical coupling. In this scheme, mechanical displacements modulate the flux in a superconducting quantum interference device (SQUID) that forms the inductor of a microwave resonant circuit. We demonstrate that this flux-mediated coupling can be tuned in situ by the magnetic flux in the SQUID, enabling nanosecond flux tuning of the optomechanical coupling. Furthermore, we observe linear scaling of the single-photon coupling rate with the in-plane magnetic transduction field, a trend with the potential to overcome the limits of capacitive optomechanics, opening the door for a new generation of groundbreaking optomechanical experiments.

We explore the superconducting phase diagram of the two-dimensional electron system at the LaAlO3/SrTiO3 interface by monitoring the frequencies of the cavity modes of a coplanar waveguide resonator fabricated in the interface itself. We determine the phase diagram of the superconducting transition as a function of the temperature and electrostatic gating, finding that both the superfluid density and the transition temperature follow a dome shape but that the two are not monotonically related. The ground state of this two-dimensional electron system is interpreted as a Josephson junction array, where a transition from long- to short-range order occurs as a function of the electronic doping. The synergy between correlated oxides and superconducting circuits is revealed to be a promising route to investigate these exotic compounds, complementary to standard magnetotransport measurements.

When a two-level system (TLS) is coupled to an electromagnetic resonator, its transition frequency changes in response to the quantum vacuum fluctuations of the electromagnetic field, a phenomenon known as the Lamb shift. Remarkably, by replacing the TLS by a harmonic oscillator, normal-mode splitting leads to a quantitatively similar shift, without taking quantum fluctuations into account. In a weakly anharmonic system, lying in between the harmonic oscillator and a TLS, the origins of such shifts can be unclear. An example of this is the dispersive shift of a transmon qubit in circuit quantum electrodynamics (QED). Although often referred to as a Lamb shift, the dispersive shift observed in spectroscopy in circuit QED could contain a significant contribution from normal-mode splitting that is not driven by quantum fluctuations, raising the question: how much of this shift is quantum in origin? Here we treat normal-mode splitting separately from shifts induced by quantum vacuum fluctuations in the Hamiltonian of a weakly anharmonic system, providing a framework for understanding the extent to which observed frequency shifts can be attributed to quantum fluctuations.

In this experiment, we couple a superconducting transmon qubit to a high-impedance 645Ω microwave resonator. Doing so leads to a large qubit-resonator coupling rate g, measured through a large vacuum Rabi splitting of 2g≃910 MHz. The coupling is a significant fraction of the qubit and resonator oscillation frequencies ω, placing our system close to the ultrastrong coupling regime (g=g/ω=0.071 on resonance). Combining this setup with a vacuum-gap transmon architecture shows the potential of reaching deep into the ultrastrong coupling g∼0.45 with transmon qubits.

Circuit quantum electrodynamics (QED) studies the interaction of artificial atoms, open transmission lines, and electromagnetic resonators fabricated from superconducting electronics. While the theory of an artificial atom coupled to one mode of a resonator is well studied, considering multiple modes leads to divergences which are not well understood. Here, we introduce a first-principles model of a multimode resonator coupled to a Josephson junction atom. Studying the model in the absence of any cutoff, in which the coupling rate to mode number n scales as n for n up to, we find that quantities such as the Lamb shift do not diverge due to a natural rescaling of the bare atomic parameters that arises directly from the circuit analysis. Introducing a cutoff in the coupling from a nonzero capacitance of the Josephson junction, we provide a physical interpretation of the decoupling of higher modes in the context of circuit analysis. In addition to explaining the convergence of the quantum Rabi model with no cutoff, our work also provides a useful framework for analyzing the ultrastrong coupling regime of a multimode circuit QED.

With the introduction of superconducting circuits into the field of quantum optics, many experimental demonstrations of the quantum physics of an artificial atom coupled to a single-mode light field have been realized. Engineering such quantum systems offers the opportunity to explore extreme regimes of light-matter interaction that are inaccessible with natural systems. For instance the coupling strength g can be increased until it is comparable with the atomic or mode frequency ω_a,m and the atom can be coupled to multiple modes which has always challenged our understanding of light-matter interaction. Here, we experimentally realize a transmon qubit in the ultra-strong coupling regime, reaching coupling ratios of g/ω_m = 0.19 and we measure multi-mode interactions through a hybridization of the qubit up to the fifth mode of the resonator. This is enabled by a qubit with 88% of its capacitance formed by a vacuum-gap capacitance with the center conductor of a coplanar waveguide resonator. In addition to potential applications in quantum information technologies due to its small size, this architecture offers the potential to further explore the regime of multi-mode ultra-strong coupling.

Ensembles of trapped atoms interacting with on-chip microwave resonators are considered as promising systems for the realization of quantum memories, novel quantum gates, and interfaces between the microwave and optical regime. Here, we demonstrate coupling of magnetically trapped ultracold Rb ground-state atoms to a coherently driven superconducting coplanar resonator on an integrated atom chip. When the cavity is driven off-resonance from the atomic transition, the microwave field strength in the cavity can be measured through observation of the AC shift of the atomic hyperfine transition frequency. When driving the cavity in resonance with the atoms, we observe Rabi oscillations between hyperfine states, demonstrating coherent control of the atomic states through the cavity field. These observations enable the preparation of coherent atomic superposition states, which are required for the implementation of an atomic quantum memory.

We experimentally investigate superconducting coplanar waveguide resonators in external magnetic fields and present two strategies to reduce field-induced dissipation channels and resonance frequency shifts. One of our approaches is to significantly reduce the superconducting ground-plane areas, which leads to reduced magnetic-field focussing and thus to lower effective magnetic fields inside the waveguide cavity. By this measure, the field-induced losses can be reduced by more than one order of magnitude in mT out-of-plane magnetic fields. When these resonators are additionally coupled inductively instead of capacitively to the microwave feed lines, an intrinsic closed superconducting loop is effectively shielding the heart of the resonator from magnetic fields by means of flux conservation. In total, we achieve a reduction of the field-induced resonance frequency shift by up to 2 orders of magnitude. We combine systematic parameter variations on the experimental side with numerical magnetic-field calculations to explain the effects of our approaches and to support our conclusions. The presented results are relevant for all areas, where high-performance superconducting resonators need to be operated in magnetic fields, e.g., for quantum hybrid devices with superconducting circuits or electron spin resonance detectors based on coplanar waveguide cavities.