Colloidal nanoplatelets (NPLs) are promising materials for lasing applications. The properties are usually discussed in the framework of 2D materials, where strong excitonic effects dominate the optical properties near the band edge. At the same time, NPLs have finite lateral dimensions such that NPLs are not true extended 2D structures. Here we study the photophysics and gain properties of CdSe/CdS/ZnS core-shell-shell NPLs upon electrochemical n doping and optical excitation. Steady-state absorption and PL spectroscopy show that excitonic effects are weaker in core-shell-shell nanoplatelets due to the decreased exciton binding energy. Transient absorption studies reveal a gain threshold of only one excitation per nanoplatelet. Using electrochemical n doping, we observe the complete bleaching of the band edge exciton transitions. Combining electrochemical doping with transient absorption spectroscopy, we demonstrate that the gain threshold is fully removed over a broad spectral range and gain coefficients of several thousand cm-1 are obtained. These doped NPLs are the best performing colloidal nanomaterial gain medium reported to date, with the lowest gain threshold and broadest gain spectrum and gain coefficients that are 4 times higher than in n-doped colloidal quantum dots. The low exciton binding energy due to the CdS and ZnS shells, in combination with the relatively small lateral size of the NPLs, results in excited states that are effectively delocalized over the entire platelet. Core-shell NPLs are thus on the border between strong confinement in QDs and dominant Coulombic effects in 2D materials. We demonstrate that this limit is in effect ideal for optical gain and that it results in an optimal lateral size of the platelets where the gain threshold per nm2 is minimal.

To improve the stability and carrier mobility of quantum dot (QD) optoelectronic devices, encapsulation or pore infilling processes are advantageous. Atomic layer deposition (ALD) is an ideal technique to infill and overcoat QD films, as it provides excellent control over film growth at the sub-nanometer scale and results in conformal coatings with mild processing conditions. Different thicknesses of crystalline ZnO films deposited on InP QD films are studied with spectrophotometry and time-resolved microwave conductivity measurements. High carrier mobilities of 4 cm² (V s)⁻¹ and charge separation between the QDs and ZnO are observed. Furthermore, the results confirm that the stability of QD thin films is strongly improved when the inorganic ALD coating is applied. Finally, proof-of-concept photovoltaic devices of InP QD films are demonstrated with an ALD-grown ZnO electron extraction layer.

Solution-processed quantum dot (QD) lasers are one of the holy grails of nanoscience. They are not yet commercialized because the lasing threshold is too high: one needs >1 exciton per QD, which is difficult to achieve because of fast nonradiative Auger recombination. The threshold can, however, be reduced by electronic doping of the QDs, which decreases the absorption near the band-edge, such that the stimulated emission (SE) can easily outcompete absorption. Here, we show that by electrochemically doping films of CdSe/CdS/ZnS QDs, we achieve quantitative control over the gain threshold. We obtain stable and reversible doping of more than two electrons per QD. We quantify the gain threshold and the charge carrier dynamics using ultrafast spectroelectrochemistry and achieve quantitative agreement between experiments and theory, including a vanishingly low gain threshold for doubly doped QDs. Over a range of wavelengths with appreciable gain coefficients, the gain thresholds reach record-low values of ∼1 × 10-5 excitons per QD. These results demonstrate a high level of control over the gain threshold in doped QD solids, opening a new route for the creation of cheap, solution-processable, low-threshold QD lasers.

Solution processed quantum dot (QD) lasers are one of the holy-grails of nanoscience. They are not yet commercialized because the lasing threshold is too high: one needs < 1 exciton per QD, which is hard to achieve due to fast non-radiative Auger recombination. The threshold can however be reduced by electronic doping of the QDs, which decreases the absorption near the band-edge, such that the stimulated emission (SE) can easily outcompete absorption. Here, we show that by electrochemically doping films of CdSe/CdS/ZnS QDs we achieve quantitative control over the gain threshold. We obtain stable and reversible doping more than two electrons per QD. We quantify the gain threshold and the charge carrier dynamics using ultrafast spectroelectrochemistry and achieve quantitative agreement between experiments and theory, including a vanishingly low gain threshold for doubly doped QDs. Over a range of wavelengths with appreciable gain coefficients, the gain thresholds reach record-low values of ∼10-5 excitons per QD. These results demonstrate an unprecedented level of control over the gain threshold in doped QD solids, paving the way for the creation of cheap, solution-processable low-threshold QD-lasers.

In transient absorption (TA) measurements on Cd-chalcogenide quantum dots (QDs), the presence of a band-edge (BE) bleach signal is commonly attributed entirely to conduction-band electrons in the 1S(e) state, neglecting contributions from BE holes. While this has been the accepted view for more than 20 years, and has often been used to distinguish electron and hole kinetics, the reason for the absence of a hole contribution to the BE-bleach has remained unclear. Here, we show with three independent experiments that holes do in fact have a significant impact on the BE-bleach of well-passivated Cd-chalcogenide QD samples. Transient absorption experiments on high photoluminescence quantum yield CdSe/CdS/ZnS core-shell-shell QDs clearly show an increase of the band-edge bleach as holes cool down to the band edge. The relative contribution of electron-to-hole bleach is 2:1, as predicted by theory. The same measurements on core-only CdSe QDs with a lower quantum yield do not show a contribution of holes to the band-edge bleach. We assign the lack of hole bleach to the presence of ultrafast hole trapping in samples with insufficient passivation of the QD surface. In addition, we show measurements of optical gain in core-shell-shell QD solutions, providing clear evidence of a significant hole contribution to the BE transient absorption signal. Finally, we present spectroelectrochemical measurements on CdTe QDs films, showing the presence of a BE-bleach for both electron and hole injections. The presence of a contribution of holes to the bleach in passivated Cd-chalcogenides QDs bears important implications for quantitative studies on optical gain as well as for TA determinations of carrier dynamics.

In this work, we systematically study the spectroelectrochemical response of CdSe quantum dots (QDs), CdSe/CdS core/shell QDs with varying CdS shell thicknesses, and CdSe/CdS/ZnS core/shell/shell QDs in order to elucidate the influence of localized surface trap states on the optoelectronic properties. By correlating the differential absorbance and the photoluminescence upon electrochemically raising the Fermi level, we reveal that trap states near the conduction band (CB) edge give rise to nonradiative recombination pathways regardless of the CdS shell thickness, evidenced by quenching of the photoluminescence before the CB edge is populated with electrons. This points in the direction of shallow trap states localized on the CdS shell surface that give rise to nonradiative recombination pathways. We suggest that these shallow trap states reduce the quantum yield because of enhanced hole trapping when the Fermi level is raised electrochemically. We show that these shallow trap states are removed when additional wide band gap ZnS shells are grown around the CdSe/CdS core/shell QDs.

Colloidal quantum dots (QDs) allow great flexibility in the design of optoelectronic devices, thanks to their size-dependent optical and electronic properties and the possibility to fabricate thin films with solution-based processing. In particular, in QD-based heterojunctions, the band gap of both components can be controlled by varying the size of the QDs. However, control over the band alignment between the two materials is required to tune the dynamics of carrier transfer across a heterostructure. We demonstrate that ligand exchange strategies can be used to control the band alignment of PbSe and CdSe QDs in a mixed QD solid, shifting it from a type-I to a type-II alignment. The change in alignment is observed in both spectroelectrochemical and transient absorption measurements, leading to a change in the energy of the conduction band edges in the two materials and in the direction of electron transfer upon photoexcitation. Our work demonstrates the possibility to tune the band offset of QD heterostructures via control of the chemical species passivating the QD surface, allowing full control over the energetics of the heterostructure without requiring changes in the QD composition.

Indium antimonide (InSb) quantum dots (QDs) have unique and interesting photophysical properties, but widespread experimentation with InSb QDs is lacking due to the difficulty in synthesizing this material. The key experimental challenge in fabricating InSb QDs is preparing a suitable Sb-precursor in the correct oxidation state that reacts with the In-precursor in a controllable manner. Here, we review and discuss the synthetic strategies for making colloidal InSb QDs and present a new reaction scheme yielding small (∼1 nm diameter) InSb QDs. This was accomplished by employing Sb(NMe₂)₃ as the antimony precursor and by screening different reducing agents that can selectively reduce it to stibine in situ. The released SbH₃, subsequently, reacts with In carboxylate to form small InSb clusters. The absorption features are moderately tunable (from 400 nm to 660 nm) by the amount and rate of reductant addition as well as the temperature of injection and subsequent annealing. Optical properties were probed with transient absorption spectroscopy and show complex time and spectral dependencies.

Thermalization losses limit the photon-to-power conversion of solar cells at the high-energy side of the solar spectrum, as electrons quickly lose their energy relaxing to the band edge. Hot-electron transfer could reduce these losses. Here, we demonstrate fast and efficient hot-electron transfer between lead selenide and cadmium selenide quantum dots assembled in a quantum-dot heterojunction solid. In this system, the energy structure of the absorber material and of the electron extracting material can be easily tuned via a variation of quantum-dot size, allowing us to tailor the energetics of the transfer process for device applications. The efficiency of the transfer process increases with excitation energy as a result of the more favorable competition between hot-electron transfer and electron cooling. The experimental picture is supported by time-domain density functional theory calculations, showing that electron density is transferred from lead selenide to cadmium selenide quantum dots on the sub-picosecond timescale.

Carrier multiplication is a process in which one absorbed photon excites two or more electrons. This is of great promise to increase the efficiency of photovoltaic devices. Until now, the factors that determine the onset energy of carrier multiplication have not been convincingly explained. We show experimentally that the onset of carrier multiplication in lead chalcogenide quantum confined and bulk crystals is due to asymmetric optical transitions. In such transitions most of the photon energy in excess of the band gap is given to either the hole or the electron. The results are confirmed and explained by theoretical tight-binding calculations of the competition between impact ionization and carrier cooling. These results are a large step forward in understanding carrier multiplication and allow for a screening of materials with an onset of carrier multiplication close to twice the band gap energy. Such materials are of great interest for development of highly efficient photovoltaic devices.

The photoluminescence (PL) quantum yield of semiconductor nanocrystals (NCs) is hampered by in-gap trap states due to dangling orbitals on the surface of the nanocrystals. While crucial for the rational design of nanocrystals, the understanding of the exact origin of trap states remains limited. Here, we treat CdTe nanocrystal films with different metal chloride salts and we study the effect on their optical properties with in situ spectroelectrochemistry, recording both changes in absorption and photoluminescence. For untreated CdTe NC films we observe a strong increase in the PL intensity as the Fermi-level is raised electrochemically and trap states in the bandgap become occupied with electrons. Upon passivation of these in-gap states we observe an increase in the steady state PL and, for the best treatments, we observe that the PL no longer depends on the position of the Fermi level in the band gap, demonstrating the effective removal of trap states. The most effective treatment is obtained for Z-type passivation with CdCl₂, for which the steady state PL increased by a factor 40 and the PL intensity became nearly unaffected by the applied potential. X-ray Photoelectron Spectroscopy measurements show that treatment with ZnCl₂ mainly leads to X-type passivation with chloride ions, which increased the PL intensity by a factor four and made the PL less susceptible to modulation by applying a potential with respect to unpassivated nanocrystal films. We elucidate the spectroelectrochemical signatures of trap states within the bandgap and conclude that undercoordinated Te at the surface constitutes the largest contribution to in-gap trap states, but that other surface states that likely originate on Cd atoms should also be considered.

Energy levels in the band gap arising from surface states can dominate the optical and electronic properties of semiconductor nanocrystal quantum dots (QDs). Recent theoretical work has predicted that such trap states in II-VI and III-V QDs arise only from two-coordinated anions on the QD surface, offering the hypothesis that Lewis acid (Z-type) ligands should be able to completely passivate these anionic trap states. In this work, we provide experimental support for this hypothesis by demonstrating that Z-type ligation is the primary cause of PL QY increase when passivating undercoordinated CdTe QDs with various metal salts. Optimized treatments with InCl₃ or CdCl₂ afford a near-unity (>90%) photoluminescence quantum yield (PL QY), whereas other metal halogen or carboxylate salts provide a smaller increase in PL QY as a result of weaker binding or steric repulsion. The addition of non-Lewis acidic ligands (amines, alkylammonium chlorides) systematically gives a much smaller but non-negligible increase in the PL QY. We discuss possible reasons for this result, which points toward a more complex and dynamic QD surface. Finally we show that Z-type metal halide ligand treatments also lead to a strong increase in the PL QY of CdSe, CdS, and InP QDs and can increase the efficiency of sintered CdTe solar cells. These results show that surface anions are the dominant source of trap states in II-VI and III-V QDs and that passivation with Lewis acidic Z-type ligands is a general strategy to fix those traps. Our work also provides a method to tune the PL QY of QD samples from nearly zero up to near-unity values, without the need to grow epitaxial shells.

We functionalize PbS nanocrystals with the organic semiconductor Zn β-tetraaminophthalocyanine to design a nanostructured solid-state material with frequent organic–inorganic interfaces. By transient absorption and fluorescence spectroscopy, we investigate the optoelectronic response of this hybrid material under near-infrared excitation to find efficient charge transfer from the nanocrystals to the molecules. We demonstrate that the material undergoes cooperative sensitization of two nanocrystals followed by photon upconversion and singlet emission of the organic semiconductor. The upconversion efficiency resembles that of comparable systems in solution, which we attribute to the large amount of interfaces present in this solid-state film. We anticipate that this synthetic strategy has great prospects for increasing the open-circuit voltage in PbS nanocrystal-based solar cells.