Bluetooth Low Energy (BLE) powers large-scale Internet-of-Things networks but remains constrained by costly off-chip crystal oscillators. This work presents a 730 μW over-the-air frequency calibration technique that compares the energy of the upper and lower sidebands of a received BLE-compliant signal to calibrate the frequency accuracy of an on-chip LC oscillator from ±340 ppm to ±20 ppm within a 1.1 ms calibration period, while maintaining robust operation under a -23 dB signal-to-interference ratio at the adjacent channel.

Addressing the advancement toward large-scale quantum computers, this article presents the first four-level pulse amplitude modulation (PAM4) wireline transmitter (TX) operating at cryogenic temperatures (CTs). With quantum computers scaling up toward thousands of quantum bits (qubits), but having too limited fidelity for robust operation, continuous rounds of quantum error correction (QEC) are necessary. However, QEC requires a large amount of data to be transferred from a cryogenic controller at 4 K to a classical processor at room temperature (RT). To bridge the gap, a high-speed data link between the quantum processor at CT and the classical counterpart at RT is needed. The proposed PAM4 TX architecture integrates a low-power 64:4 serializer structure, a high-speed 4:1 current-mode logic (CML) multiplexer, and a linear 6-bit digital-to-analog converter (DAC). Considering the challenges and benefits of CMOS operating at CTs, the TX architecture and circuitry are designed to exploit the maximum speed, while maintaining sufficient linearity. The fabricated 40-nm CMOS chip achieves a data rate of 40-Gb/s (36-Gb/s), an energy efficiency of 2.46 pJ/b (2.47 pJ/b), and 97.8% (96.6%) ratio of level mismatch (RLM) at CT (RT). While demonstrating an energy efficiency comparable to prior-art TXs in more advanced CMOS nodes at RT, the broad operating temperature of the proposed TX enables the required high-speed wireline link for large-scale quantum computers.

Color-center quantum bits (qubits), such as the Nitrogen-Vacancy center (NV) in diamond, have demonstrated entanglement between remote (>1.3km) qubits and excellent coherence times [1], all while operating at a few Kelvins. Compared to other qubit technologies typically operating at mK temperatures, the higher operating temperature of NVs enables scalable 3D integration with cryo-CMOS control electronics [2], provides significantly more cooling power, and removes the interconnect bottleneck between the qubits and the electronics in prior art [3-5]. Yet, no cryo-CMOS controller for NV-based quantum computers (QC) has been demonstrated.

Striving toward a scalable quantum processor, this article presents the first cryo-CMOS quantum bit (qubit) controller targeting color centers in diamond. Color-center qubits enable a modular architecture that allows for the 3-D integration of photonics, cryo-CMOS control electronics, and qubits in the same package. However, performing quantum operations in a scalable manner requires large currents in the driving coils due to low coil-to-qubit coupling. Moreover, active calibration of the qubit Larmor frequency is required to compensate inhomogeneities of the bias magnetic field. To overcome these challenges, this work proposes both a cryo-CMOS alternating current (AC) controller consisting of a class-DE series-resonant driver and a DC current regulator (DC CR) that uses a triode-biased H-bridge for scalable low-power qubit operations. By experimentally validating the cryo-CMOS performance with a nitrogen-vacancy (NV) color-center qubit, the AC controller can drive a Rabi oscillation up to 2.5 MHz with a supply draw of 6.5 mA, and the DC CR can tune the Larmor frequency by ±9 MHz while driving up to ±20 mA in the bias coil. T ^∗ ₂ coherence times up to 5.3μs and single-qubit gate fidelities above 98% are demonstrated with the cryo-CMOS control using Ramsey experiments and gate set tomography (GST), respectively. The results demonstrate the efficacy of the proposed cryo-CMOS chips and enable the development of a modular quantum processor based on color centers.

State-of-the-art quantum computers already comprise hundreds of cryogenic quantum bits (qubits), and prototypes with over 10k qubits are currently being developed. Such large-scale systems require local cryogenic electronics for qubit control and readout, leaving the digital controllers for algorithm execution and quantum error correction (QEC) at room temperature due to the limited cryogenic cooling budget. The entire process, including qubit readout, data transmission, QEC, and algorithm execution, should be completed well within the qubit decoherence time, thus requiring a low-power high-speed communication link between the cryogenic quantum processor and classical processor located at room temperature. To this end, this paper presents the first cryo-CMOS high-speed 4-level pulse amplitude modulation (PAM4) wireline transmitter. Thanks to a power-efficient serializing architecture driving a 6-bit digital-to-analog converter (DAC), the 40-nm CMOS chip achieves a data rate of 40 Gb/s PAM4 with an efficiency of 2.46pJ/b and a ratio of level mismatch (RLM) of 97.8% at 4.2 K. While demonstrating an energy efficiency comparable to state-of-the-art transmitters in more advanced CMOS nodes, the extremely wide temperature operating range (4.2 K - 300 K) will enable future large-scale quantum computers.