Sintered Cu nanoparticles (NPs) are promising for high-performance electronics due to their excellent thermal and electrical conductivity, as well as mechanical reliability. This study investigates the microscale mechanical behavior of sintered Cu NPs with a bimodal particle size distribution, focusing on strain rate and temperature effects. Micro-pillar compression tests were performed across strain rates of 0.0001 s⁻¹ to 0.01 s⁻¹ and temperatures from 25 °C to 350 °C. Results show that higher strain rates enhance yield strength through strain-rate hardening, while elevated temperatures lead to thermal softening and reduced mechanical stability. The Anand viscoplastic model accurately predicts these deformation behaviors. Microstructural analysis via scanning electron microscopy (SEM) and transmission electron microscopy (TEM) reveals localized deformation at 175 °C, with dislocations concentrated near the top surface and persistent porosity below, whereas at 350 °C, re-sintering and grain boundary diffusion create a denser microstructure. Phase-field fracture modeling further elucidates crack propagation, emphasizing the role of pore size and temperature. This combined experimental and modeling approach enhances understanding of viscoplastic deformation and fracture mechanisms in sintered Cu NPs, informing their use in interconnects, power electronics and thermal management systems.

Silicon carbide (SiC) coated vertically aligned carbon nanotubes (VACNT) are attractive material for fabricating MEMS devices as an alternative for bulk micromachining of SiC. In order to examine the mechanical properties of SiC-CNT composites at high temperatures, we fabricated VACNT micro-pillars with different amounts of SiC coating and performed high-temperature micro-pillar compression on these samples. The indentation result shows that the coating can improve the elastic modulus up to three orders of magnitude. Samples were tested at room temperature, 300°C, 600°C, and 900°C under compressive load. No significant degradation of the mechanical properties was observed at elevated temperatures, demonstrating the harsh environment potential of this composite.

To fulfill the high-temperature application requirement of high-power electronics packaging, Cu nanoparticle sintering technology, with benefits in low-temperature processing and high-melting point, has attracted considerable attention as a promising candidate for the die-attach interconnect. Comprehensive mechanical characterization of the sintered layer at a microscale is necessary to deepen the understanding of the fracture behavior and improve the reliable design of materials. In this study, microscale cantilevers with different notch depths were fabricated in a 20 MPa sintered interconnect layer. Continuous dynamical fracture testing of the microcantilevers was conducted in situ in a scanning electron microscope to detail the failure characteristic of the porous sintered structure. The microscopic fracture toughness of different notched specimens was obtained from the J-integral in the frame of elastic-plastic fracture mechanics. Specimens with deeper notches presented higher resistance to crack extension, while geometry factors of notch-to-width ratio between 0.20 and 0.37 exhibited a relatively stable microscopic fracture toughness ranging from 3.2 ± 0.3 to 3.6 ± 0.1 MPa m^1/2.