Radiative near-field links have gained noticeable interests recently for high-data-rate wireless communication. Unlike far-field links, near-field links can have negligible path loss within hundreds of meters for electrically large antennas at high frequencies. In this work, we propose a multi-lens quasi-optical (QO) system for 100-m near-field backhaul communication at H-band. The QO system is designed with compact size (aspect ratio of 1.3:1) and high coupling efficiency of 82%. Moreover, the rotation of an auxiliary lens realizes beam scanning for the link alignment. The scan range is in the order of 1 m with less than 2 dB scanning coupling loss and scanning magnification of 14.5:1.

This work presents an electrically-small lens that has been redesigned towards a flat interface. This way, the lens is easier to integrated, compared to an earlier introduced spherical core-shell lens concept. The lens is created from a single dielectric host material by conformally machining holes into the material. In this process, two artificial dielectric layers are created; The first layer is used for anti-reflection purposes, whereas the second is used to convert the spherical interface to a flat interface. The two layers enable the use of holes with lower aspect ratio drilling, compared to classical gradient-index lenses. The lens is designed to operate in the 140-170 GHz bandwidth, and a prototype with height of only 2.2 mm and diameter of 6.6 mm was fabricated and characterize. The prototype is small enough to fit in many integrated circuit packages. The flat lens was compared to a non-flat core lens in terms of pattern quality, return loss and dielectric loss, with only negligible performance degradation.

The search for extraterrestrial bio-signatures and the origin of Earth’s water remain two of the most compelling questions in planetary science. While no direct evidence of life beyond Earth has been found, water is a key prerequisite for life, and tracing its presence throughout the solar system may provide vital clues. A leading theory suggests that Earth’s water may have originated from comets, supported by limited water isotopic measurements that match Earth’s ocean water. However, more data from a larger sample of comets is needed to validate this theory. Traditional sub-millimeter wave spectrometers, capable of such measurements, are often too large and power-intensive for small spacecraft platforms. To address this, we present WHATSUP—a next-generation, ultra-compact, low-power, room-temperature submillimeter-wave (500-600 GHz) spectrometer—designed primarily for CubeSat and SmallSat platforms, though equally well-suited for a range of other missions. WHATSUP utilizes advances in CMOS system-on-chip electronics, innovative low profile and low mass silicon lens antenna, Micro-electro mechanical system (MEMS)-based THz switching, and a novel programmable calibration load. Together, these innovations deliver a highly integrated system with a total mass of only 2 kg and power consumption under 7 W, which is a substantial improvement over previous submillimeter-wave instruments. This enables affordable, high-frequency spectral observations from multiple low-cost missions, potentially revolutionizing how isotopic studies of cometary water are conducted and opening new pathways for outer solar system exploration. WHATSUP instrument was flown on the NASA Hand Launch Payload (HLP) ballooncraft and performed atmospheric soundings across Texas, USA in July 2023.

This contribution presents the measurement strategy to accurately characterize probe-fed high-gain antennas operating in the sub-THz band. First, a near-field technique employing a quasi-optical system is introduced to enable characterization of backside radiating antennas (with respect to the landing pads). The proposed setup employs classical manipulators for probe landing (i.e., above the structure) and linear xyz CNC controlled translation stage. After, the calibration and modelling techniques to allow for an accurate input reflection-coefficient at the antenna input plane, and the estimation of the antenna gain, in a near field planar scanning system, are described in details. The experimental data of an high-gain backside-radiating lens antenna operating in D-band are presented to validate the proposed approach and characterization bench.

This article introduces a novel transmit lens array with beam-steering capabilities for submillimeter-wave space instruments. The transmit array consists of two sparse silicon lens antenna arrays connected by a waveguide array, in which active components can potentially be integrated, arranged in a hexagonal grid. The upper lens array is mechanically actuated to achieve dynamic beam-steering. The bottom lens array is fed coherently by a quasi-optical (QO) power distribution lens antenna. This antenna is capable of distributing power to a multipixel lens array in a hexagonal configuration with a power coupling efficiency of approximately 60%. The transmit lens array and QO power distribution lens antennas are based on a recently developed multimode leaky-wave feed, which results in lens antenna aperture efficiencies of nearly 80%. A model based on high-frequency techniques has been implemented to design and optimize the complete architecture, allowing to evaluate its directivity and gain. We have fabricated and measured a prototype based on seven-lens elements with excellent agreement to the performances estimated by the model. This article demonstrates for the first time an array architecture that reaches 36 dBi directivity, 32 dBi gain, and +/-25° scanning with 3 dB scan loss over a 450-650 GHz band.

In this contribution, we describe a reconfigurable surface, designed in 130um SiGe technology, to realize a fully-electronic, planar chopper aiming at passive terahertz imaging applications. This surface consists of subwavelength metallic patches that are interconnected using FET-based varactors. By switching the bias voltage of the varactors between 0V and 1.2V, the reconfigurable surface can switch between a transmissive and opaque state, respectively. The expected transmissivity is simulated to be between 0.2 and 0.9 over a wide frequency band, from 250 GHz to 550 GHz. This chopping solution would enable a high degree of system integration for future passive terahertz cameras.

This article presents the development of a focal plane array (FPA) for terahertz imaging applications with a near diffraction-limited resolution achieved through a very tight sampling of the focal plane. The antenna array is integrated with direct detectors in a 22-nm CMOS technology and operates from 200 to 600 GHz. The tight sampling of the focal plane is realized by using a combination of leaky-wave radiation and a dual-polarized connected array configuration that closely resembles a chessboard. By utilizing both the polarizations in the chessboard design, the number of array elements per unit area is effectively doubled. The geometry of the chessboard array was co-optimized together with that of a silicon elliptical lens to achieve both high aperture efficiency and beam overlap. Measurements in the WR2.2 band of a fabricated demonstrator showed that an aperture efficiency of −4.1 dB was realized at 400 GHz. The average gain roll-off between two diagonally adjacent array elements was measured to be −1.5 dB at 400 GHz. Compared to the reference configuration of an idealized, equivalently sampled hexagonal FPA, the improvement in gain at the edge of coverage yields 1.2 dB, which includes 1.9 dB of ohmic losses in the chessboard array. The agreement between measurements and simulations proved to be within 1 dB from 325 to 475 GHz.

The design of a focal plane array (FPA) for imaging at sub-mm wavelengths generally is a trade-off between resolution and sensitivity. For maximum angular resolution, minimal spacing between FPA elements is desired, which leads to increased losses due to spillover and mutual coupling and therefore deteriorates the imaging sensitivity. This work presents the characterization of an ultra-wideband (200 GHz 600 GHz) FPA with integrated direct-detectors, achieving a tight sampling of the focal plane by implementing overlapping of the feed elements, hence alleviating the penalty in aperture efficiency. The overlapping of the feed elements in implemented using a combination of a dual-polarized connected array configuration resembling a chessboard, and leaky-wave propagation in the CMOS stratification. The measured radiation patterns and aperture efficiency show

The continuous advancements in the coverage and sensitivity of terahertz direct-detector imagers places increasing constraints on the test benches needed for characterization. Already, relative differences on the order of a few decibels are observed between simulated and measured performance in the state-of-the-art literature. This contribution elaborates on our experimental strategies to maximize the characterization accuracy and precision of terahertz direct-detection imagers using a broadband, over-the-air measurement procedure. As a demonstration, four elements within a dense detector array were characterized in the WR2.2 band. By optimizing the modulation frequency in the setup for minimal impact of low-frequency noise and interference, a measurement dynamic range up to 30 dB was achieved, including the path loss over 20 cm. The hardware-to-model agreement of the characterized array is below 1 dB between 325 and 450 GHz.

In this paper, we present a quasi-optical power distribution architecture based on the use of an integrated lens antenna that generates a uniform aperture field distribution. By using such distribution in combination with an integrated lens array, an efficient and scalable quasi-optical power distribution can be achieved at THz frequencies. The proposed architecture is based on a leaky-wave waveguide feed that illuminates an elliptical lens with a top-hat distribution. This method can distribute the power from one antenna to a 7-pixel lens array in a hexagonal configuration with a power coupling efficiency of nearly 60%. This scheme could be potentially used for the local oscillator power distribution in heterodyne THz arrays. A prototype at 450-615GHz has been developed and characterized, achieving an aperture efficiency higher than 80%.

Terahertz heterodyne spectrometer instruments have been traditionally limited to a single pixel or a handful of pixels due to integration and assembly constraints and a limited availability of local oscillator (LO) power. As a solution we propose a novel silicon-micromachined planar and modular packaging strategy, that will allow for a dense integration of a large number of pixels. Moreover, the RF- and LO signals will be quasi-optically coupled via two identical but opposite lens arrays, such that a single LO-source can efficiently pump all HEB-mixers of the 2x2 pixel demonstrator array simultaneously. This work reports on an intermediate step, where we validate the lens array performance and LO power coupling efficiency, by slightly modifying the silicon package into a transmit array configuration. In this way, the LO power coupled into the stack is directly reradiated on the other side, which is then measured using a liquid helium cooled bolometer.

This contribution presents the development of an electrically small lens antenna using an artificially loaded thermoplastic at 140-170GHz. We will present the on-going development of the Fly’s Eye front end antenna concept that was presented in [1]. The antenna is composed on a dual plastic lens, a core lens and a shell lens, fed by a double slot. The core-lens, being presented in this contribution, is a spherical lens made from an artificially loaded plastic of permittivity 9.5. To the best of our knowledge, this thermoplastic material has not been used for lens antennas in this frequency range before. A 4mm lens prototype has been developed using this material, which includes an antireflective layer synthesized by drilling sub-wavelength holes on the lens contour. Full-wave simulations show a negligible degradation of the performance of the anti-reflection layer compared to an ideal homogeneous matching layer. Physical measurements and antenna measurements confirm that the antenna's performance matches the design specifications.

The development of a low focal number and low-mass lens antenna is presented that enables terahertz spectroscopy applications on ultracompact platforms. The antenna operates efficiently over a 20% fractional bandwidth, from 450 to 550 GHz, with a gain of 50 dBi at 500 GHz. The antenna consists of a hyperbolic silicon lens that is placed in a record low focal number configuration (f_#=0.27) with respect to an advanced waveguide feed. An incident field-matching analysis is applied to investigate the optimal feed radiation pattern that maximizes the lens aperture efficiency, which would result in a 20% increase in aperture efficiency (> 80%) with respect to a standard open-ended waveguide (< 60% aperture efficiency). A multilayer leaky-wave (LW) stratification is quasi-analytically optimized to approximate the optimal feeding pattern, resulting in a >70% lens aperture efficiency. An example LW stratification is synthesized using silicon micromachining technology and is fully characterized in combination with the dielectric lens.

The exploration of icy body composition in the solar system has often involved spectroscopic measurements of volatiles detected with remote sensing, such measurements portray materials naturally expelled from the surface that enter the exosphere and potentially escape into space. Variations in the ratio of deuterium and hydrogen in these measurements have led to inconclusive hypotheses regarding potential cometary origins of Earth’s ocean water and/or organics. Observational biases regarding unknown previous processing of the observable ejected materials necessitates studies of more dormant, less-processed bodies. Landed missions on comets have brought focus onto the development of small, sensitive instrumentation capable of similar composition measurements of the nascent surface and near-surface materials. We present an evolution of our compact Fourier-transform millimeter-wave cavity spectrometer that is tuned for sensitivity at 80.6 and 183 GHz where HDO and H₂O exhibit resonance features. We discuss both a low-SWaP (size-weight and power) architecture that uses custom microchip transceiver elements as well as a modular configuration using traditional GaAs-based millimeter-wave hardware. New design features for these systems including quartz-based coupling elements, system thermal management, and a separable clocking board are discussed in addition to sensitivity studies and applications in potential mission scenarios.

A novel transmit lens array is proposed to provide broadband quasi-optical power distribution and beam-steering capabilities for array architectures in future submillimeter-wave heterodyne instruments. The transmit array is composed of a double array layer of lens antenna elements with high aperture efficiency. To enable broadband and low loss quasi-optical (QO) power distribution, the transmit lens array is coupled with a high aperture efficiency single lens antenna. The high aperture efficiency is achieved by using a recently introduced multi-mode leaky wave feed. The top lens array can be used to achieve beam-steering capabilities when fed coherently and mechanically translated using a piezo-motor. In this contribution, we present the development of a prototype based on a transmit lens array of 7 elements at 450-650 GHz with measurements showing a good agreement with simulations. This prototype demonstrates a quasi-optical power coupling efficiency of nearly 60%. Moreover it also shows beam-steering of a 36dBi directivity beam to few discrete angles up to +/-25 degrees with less than 2dB scan loss

We present the design, fabrication and characterization of a broadband lossless matching layer for silicon lens arrays. The proposed matching layer is based on silicon frusta (truncated pyramids) on top of the lens array fabricated by means of laser ablation. This matching layer is advantageous over quarter-wavelength dielectric matching layers since it covers more than an octave of bandwidth. We compare the performance of this matching layer with the commonly-used parylene-C matching layer at the center of the targetted band (500 GHz) in a lens-antenna integrated system. We measure a 1.6 dB higher transmission of the proposed silicon frusta matching compared to the parylene-C matching layer.

In this contribution we will present the diffraction-limited imaging capabilities of a focal plane array (FPA) of antenna-coupled direct-detectors at submillimeter wavelengths. The FPA prototype is a tightly sampled, 12-pixel array that was developed in a 22 nm CMOS technology and it covers a band from 200 GHz to 600 GHz. A quasi-optical (QO) setup was developed to actively illuminate this FPA in order to perform imaging with > 40 dB SNR. The resulting images will be the first that have diffraction-limited angular resolution at these wavelengths, which demonstrates that this FPA design can be very attractive for future passive THz imaging applications.

We present a resonant leaky-wave lens antenna, fed by a circular waveguide with annular corrugations in the ground plane. The proposed leaky-wave feed reduces the impact of the spurious TM0 leaky-wave mode in all planes over a wide bandwidth while reducing assembly complexity compared to previous methods. The proposed leaky-wave antenna has an aperture efficiency above 80%, a return loss below -15 dB, and a cross-polarization level below -20 dB over a bandwidth from 110-220 GHz (2:1). We have fabricated and measured a WR-5 band (140-220 GHz) antenna prototype with a lens diameter of 3 cm that achieves excellent agreement between measurement and simulation in terms of return loss, directivity, and gain.